陈增辉,谢华.Ni-P-PTFE化学复合镀的工艺研究[J].表面技术,2007,36(3):46-48.
CHEN Zeng-hui,XIE Hua.Study on the Process of Electroless Ni-P-PTFE Composite Plating[J].Surface Technology,2007,36(3):46-48
Ni-P-PTFE化学复合镀的工艺研究
Study on the Process of Electroless Ni-P-PTFE Composite Plating
投稿时间:2007-02-05  修订日期:2007-06-10
DOI:
中文关键词:  化学复合镀  Ni-P-PTFE  复合镀层
英文关键词:Electroless composite plating  Ni-P-PTFE  Composite coating
基金项目:福建省科技厅重点项目(2005 H013)
作者单位
陈增辉 福州大学机械工程及自动化学院,福建福州350002 
谢华 福州大学机械工程及自动化学院,福建福州350002 
AuthorInstitution
CHEN Zeng-hui Institute of Mechanical Engineering and Automation, Fuzhou University, 350002 , China 
XIE Hua Institute of Mechanical Engineering and Automation, Fuzhou University, 350002 , China 
摘要点击次数:
全文下载次数:
中文摘要:
      用化学镀的方法制备了Ni-P-PTFE复合镀层。为了确定合适的工艺,研究了Ni-P-PTFE化学复合镀的工艺中温度、pH值、表面活性剂等参数对镀速、镀层中PTFE含量和硬度的影响。试验表明:温度和pH值升高,镀速增大,PTFE含量先升高再降低,硬度下降;FC4表面活性剂的加入量增大,镀速下降、PTFE含量先升高再降低,硬度下降。在此基础上确定了工艺参数,温度850C,pH值4.4-4.6,PTFE含量8mUL,FC4表面活性剂的加入量为0.4g/L。
英文摘要:
      Ni-P-PTFE composite coating was prepared by Electroless plating method. In order to determine fit process , the effect of temperature , pH value and surfactant on deposition rate , PTFE content in coatings and hardness in the process of electroless Ni-P-PTFE composite plating was studied. The results show that the increase of temperature and pH value results in the decrease of deposition rate, PTFE content firstly increased then decreased, hardness decreased; and the increase of FC4 surfactant results in deposition rate tends to decrease, PTFE content firstly increased then decreased, hardness decreased. On this basis, the process parameters are found : T = 850C , pH =4. 44. 6, PTFE content = 8ml/L, FC4 = 0. 4g/L.
查看全文  查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第23445861位访问者    渝ICP备15012534号-3

版权所有:《表面技术》编辑部 2014 surface-techj.com, All Rights Reserved

邮编:400039 电话:023-68792193传真:023-68792396 Email: bmjs@surface-techj.com

渝公网安备 50010702501715号